Gateway E SERIES E-6000 Manual de usuario descargar pdf (Pagina 141)

135

Troubleshooting

support.gateway.com

You see a “Disk is full” error message

■ Delete unnecessary files on the diskette.

■ Try a different diskette. Occasionally diskettes are flawed and cannot be

read by the diskette drive.

■ Run Error checking on the diskette. For more information, see “Checking

the hard drive for errors” on page 61. If errors are detected and corrected,

try using the diskette again.

You see a “Non-system disk” or “Disk error” error message

■ Eject the diskette from the diskette drive, then press ENTER.

■ Make sure that the diskette you are using is IBM-compatible.

The diskette drive LED is lit continuously

■ Remove the diskette from the drive. If the light stays on, try restarting your

computer.

■ Open the computer case and make sure that the cables are connected

correctly to the diskette drive and the system board. The red-striped edge

of the data ribbon cable indicates Pin 1 and corresponds with Pin 1 on the

diskette drive (typically on the side farthest from the power supply

connection). If necessary, reverse one end of the cable so the red-striped

edge of the data ribbon cable faces Pin 1 on the diskette drive. Make sure

that the pins are not bent or misaligned. For more information, see

“Adding or replacing a drive” on page 97.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 189 190

Sin comentarios

Gateway E SERIES E-6000 Manual de usuario Pagina 141