Gateway E3400 Manual de usuario Pagina 66

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 126
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 65
Replacing or adding a processor 59
Replacing or adding a processor
Your system board currently supports the Intel
®
Pentium III (FC-PGA 370)
i256K processor. See the Gateway Web site at www.gatewayatwork.com for
updates on processor speeds supported by your system.
When replacing a processor, order a Pentium III processor upgrade kit. The
kit includes the Pentium III processor, a heat sink, and a disposable
electrostatic wrist strap.
To replace the processor you must perform the following tasks:
Remove the heat sink
Remove the processor
Install the new processor
Replace the heat sink
To remove the heat sink:
1 Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
2 Open the case (see “Opening the case” on page 19), observing the “Static
electricity precautions” on page 17.
3 Remove the heat sink by disconnecting the fan cable from the fan
connector on the system board. (See “System board” on page 8 for the
location of the fan connector.)
Important A heat sink must be installed on the Pentium III
processor.
05957.book Page 59 Monday, May 8, 2000 10:09 AM
Vista de pagina 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 125 126

Comentarios a estos manuales

Sin comentarios